Setting the Amount of Rinse Aid Required
3 Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from
1.Open the dishwasher door.
2.Press the release button on the rinse
aid compartment.
3.Open the cover.
4.Set the dosage level.
5. Press the lid shut until it clicks into place.
6. If rinse aid has leaked out, wipe it away with a cloth.
Activating/deactivating the acoustic signal
In addition to the optical display (e.g. indicating the end of the cycle, errors) you can also choose to set an acoustic signal.
1.Press the ON/OFF button.
3 If a programme display is illuminated, this wash programme is activat- ed. The wash programme must be deselected:
Press and hold the programme button for approx. 3 seconds.
The programme display goes out. The indicator for the end of the wash programme flashes.
2.Press the programme button.The indicator for the programme button will flash.
Programme display 2 will light up.
3.Press the programme button again within 3 seconds.
The indicator for the programme button will change from flashing to continual illumination and will go out after approx. 3 seconds. Programme display 2 flashes.
The end of wash programme indicator displays the current setting:
End of wash programme indicator | Acoustic signal activated |
is illuminated: | (factory setting) |
End of wash programme indicator | Acoustic signal deactivated |
is not illuminated: |
|
11