2.Press and hold the programme button for approx. 3 seconds. Programme display 2 will light up and go out after approx. 3 seconds. The indicator for the programme button will flash.
The indicator for the end of the dishwashing cycle will flash simultane- ously:
–The number of times that the indicator for the end of the dishwash- ing cycle flashes corresponds to the hardness setting.
–This sequence of flashes is repeated several times, with a 3 second pause in between.
3.Pressing the programme button increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10).
4.When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control indicator for special salt.
| Water hardness |
| Adjusting the hardness | Number of | ||||
|
|
| setting | |||||
|
|
|
|
|
| |||
in °d1) |
| in mmol/l2) | Range | Manual |
| Electronic | flashes | |
|
| |||||||
|
|
| ||||||
51 - 70 |
| 9,0 - 12,5 |
|
|
|
| 103) | 10 |
43 - 50 |
| 7,6 - 8,9 |
|
|
|
| 9 | 9 |
37 - 42 |
| 6,5 - 7,5 |
| IV | 1 |
| 8 | 8 |
29 - 36 |
| 5,1 - 6,4 |
|
|
|
| 7 | 7 |
23 - 28 |
| 4,0 - 5,0 |
|
|
|
| 6 | 6 |
19 - 22 |
| 3,3 - 3,9 |
| III |
|
| 5 | 5 |
15 - 18 |
| 2,6 - 3,2 |
|
|
| 4* | 4 | |
|
|
|
|
| ||||
11 - 14 |
| 1,9 - 2,5 |
| II | 0* |
| 3 | 3 |
|
|
|
|
|
|
|
| |
4 - 10 |
| 0,7 - 1,8 |
| I/II |
| 2 | 2 | |
|
|
|
| |||||
below 4 |
| below 0.7 | I |
|
| 1 | 1 | |
|
|
| no salt | |||||
|
|
|
|
|
|
| necessary |
|
|
|
|
|
|
|
|
|
|
1)(°d) German degree, measure of the hardness of water
2)[mmol/l] millimol per litre, international unit for water hardness
3)On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting
8