Electrolux 40300 manual Unscrew the screws 1 from the elbows on the back side

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

4

5

•The dishwasher must also be screwed on tightly to the work surface or to the adjoining units. This is absolutely necessary so that its sta- bility is guaranteed according to VDE regulations.

1If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted.

3 The plinth on free-standing appliances is not adjustable.

30