Installation and Connection Instructions
Connecting the Dishwasher
Water Connection
The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations.
•The dishwasher can be connected to cold and hot water supplies up to max. 60 °C.
•The dishwasher must not be connected to open hot water appliances or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure: | Consult your installer if the water pres- |
1 bar (=10 N/cm2 =100 kPa) | sure is less than 1 bar. |
Highest permitted water pressure: | In the case of a water pressure greater |
10 bar (=100 N/cm2 =1 MPa) | than 10 bar, a pressure reduction valve |
| must be used (available from your |
| dealer). |
|
|
| Connect the inlet hose |
1 | The water inlet hose must not be kinked, crushed or entangled when it |
| is being connected up. |
0Connect the threaded hose fitting (DIN 259) on the water inlet hose to a tap with an external thread (¾ inch). Tighten the threaded hose fit- ting hand tight only.
3 | • In order that access to the tap in the kitchen is not limited by the use |
| of the dishwasher, we recommend the installation of an additional |
tap, or fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, VDE approved complete hose sets are to be used. These are available from your local Service Force Centre.
31
