Electrolux 57" Gas Grill Lighting the Grill

Lighting the Grill

BEFORE LIGHTING

Important! Before Lighting...

Check the gas supply line for cuts, wear or abrasion.

Always keep your face and body as far away from the

grill as possible when lighting.

GRILL BURNER LIGHTING

This unit comes equipped with (2) electronic starters and

(6) electrodes. The electronic igniter located on the

right shelf lights the side burner and the bottom

infrared burner. The electronic igniter on the left shelf

lights the main burners, which are controlled by knobs

2, 3, 4, 5, 6 and the back infrared burner.

LIGHTING THE GRILL WITH ELECTRONIC IGNITERS

Always open the lid before attempting lighting. Push and

turn one of the control knobs counter clockwise to the

“HIGH” position and immediately press the electronic

igniter button. You’ll hear a snapping sound. It may be

necessary to hold the electronic igniter button for about

4seconds. If the burner does not light in 4 seconds, turn

the knob to OFF and wait 5 minutes before trying again.

Repeat above steps to light remaining burners.

(See Fig. 16)

MATCH LIGHTING

If by chance the electronic igniter does not light the

burner,the burner may be lit with a match. Attach the

match to the match extender, located inside the right

cart door.

Keep your face as far away from the grill surface as pos-

sible and pass the match extender through the spaces

in the grill grates to the ports of the back crossover

burner between the flavor grids. Position the match

near the burnerports, then push and turn the control

knob counter clockwise to the “HIGH” position. (See Fig.

17-18)

NOTE: If the grill will not light after several attempts

see the trouble-shooting section of this manual. Turn

the control knobs to the OFF position when not in use.

Do not attempt to

“Light” the grill if the

odor of gas is present!!

Fig. 16

Fig. 17

Fig. 18

Crossover Burner

CONTROLKNOB LAYOUT:

The control knob bezel has

stamped markings for the HIGH

and LOW settings. Turning the

knob so the arrow faces the left

is the HIGHsetting. Turning the

knob so the arrow faces down

is the LOWsetting.

Right electronic igniter for

bottom infrared burner

(knob #1) & side burner

(knobs #SB1 & #SB2)

Left electronic igniter

for main burners #2, #3,

#4, #5, #6 and back

infrared burner

Back

Infrared Knob

#1Knob

#SB2

Knob

#5Knob

#3Knob

Knob

#6Knob

#SB2