The Optical Tube
Objective Lens
Tube Ring
Clamp
Dovetail / Photo
Tripod Mount
Focuser Knob
Finderscope
Finderscope
Bracket
Focuser
Installing the Finderscope
To install the finderscope onto the telescope you must first mount the finderscope through the finder bracket and then attach it to the telescope. Toward the rear of the telescope tube, near the focusing assembly, there is a small bracket with a set screw in it. This is where the finderscope bracket will be mounted. To install the finderscope:
1.Slide the rubber
2.Insert the eyepiece end of the finderscope through the bracket until the
3.Tighten the adjustment screws until they make contact with the finderscope body.
4.Locate the mounting bracket near the front (open) end of the telescope.
5. Loosen the set screw on the mounting bracket on the telescope. | Figure |
6.Slide the finder bracket (attached to the finderscope) into the mounting bracket on the telescope.
7.The finderscope bracket will slide in from the back. The finderscope should be oriented so that the objective lens is toward the front (open) end of the telescope.
8.Tighten the set screw on the mounting bracket to hold the finderscope in place.
For information on aligning your finderscope, see Telescope Basics section of this manual.
10