Installation 37

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Changing door stop

WARNING!

The door stop may only be changed by a specialist. If necessary, please contact our after-sales service or your specialist dealer.

WARNING!

Before changing the door stop, disconnect the mains plug.

1.Open loading door.

2.Unscrew hinge A from the front of the machine and take off the loading door.

3.Remove cover plates B and C. To do this, insert a thin screwdriver into the slots as shown in the illustration, press down- wards slightly and pry out the cover plates.

4.Use an appropriate tool and exert pres- sure to unfasten locking block D from the snap-on fixture, take out and re-in- sert on the other side having rotated the block through 180°.

5.Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down.

A

C

B

D

A

C

6.Re-insert cover plates B and C on the opposite site having first rotated them through 180°.

Page 37
Image 37
Electrolux 59840 user manual Permanent connection, Changing door stop