Drying cycle complete / removing laundry
Once the drying cycle is complete, display shows a blinking "0", under anti-
crease icon appear dash. If the BUZZER button has been pressed, an acoustic
signal sounds intermittently for about one minute.
The drying cycles (except for the WOOL programme) are automatically followed
by an anti-crease phase which lasts around 30 minutes. The drum rotates at in-
tervals during this phase. This keeps the laundry loose and free of creases. The
laundry can be removed at any time during the anti-crease phase. (The laundry
should be taken out towards the end of the anti-crease phase at the latest to
prevent creases from forming.) If LONG ANTI-CREASE function has been
selected, the anti-crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best
to use a damp hand for this purpose. (See “Care and cleaning” chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF.
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter “Care and cleaning”.)
5. Close the door.
20 Daily use