Onto a sink outlet spigot | Electrolux 63742 VI manual

40Installation

When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.

If your drain hose looks like this (see the relevant picture) you do not require the “U” piece”. Just push the hose firmly into the standpipe.

3pin

Max. 90 cm. (35.4")

Min.60 cm. (23.6")

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see dia- gram) to prevent waste from the sink entering the

washing machine.

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.

If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U -Piece” supplied.

Loop

Image 40

Electrolux 63742 VI manual Onto a sink outlet spigot

Contents

Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hints Prior to using for the first time Safety informationGeneral safety Installation Child Safety Use Product description Compartment for prewash phase or stain removerDetergent dispenser drawer Table of symbols Control panel Child safety lock 10.1 10.2 Acoustic signals Child safety lockFirst Use Personalisation Daily Use Load the laundryMeasure out the detergent and the fabric softener Pull out the dispenser drawer until it Machine is now switched on Programme option button Select the Prewash option ButtonSelect the Stain option Button Select the Sensitive option Button Select the Time option Button Select the Delay Start ButtonSelect the START/PAUSE Button Altering an option or a running programme Select an additional rinseInterrupting a programme Cancelling a programme Opening the door after the programme has startedAt the end of the programme 10.2 go off and a blinking 0 will appear on the display Non-shrink shirts Washing programmesBlouses Spin Programme information Temperatures Preparing the wash cycleSorting out the laundry Before loading the laundry Following weights are indicative Laundry weightsMaximum loads Removing stains Detergents and additives Quantity of detergent to be used Degrees of water hardnessPowder detergents for delicate fabrics 60C max and woollens Marked before starting the wash programme Care and cleaning Washing drum Door seal Drain pump Water inlet filter Emergency emptying out Frost precautions Possible cause/Solution What to do if Machine fills then empties immediately Cause possible/Solution Technical Data Consumption value Unpacking InstallationPolystyrene base from the bottom Six smaller bolts C Positioning and levelling Water inlet Water-stop device Water drainage Onto a sink outlet spigot Interest of the environment Electrical connectionWith the following code Green and Yellow Earth Blue Permanent connection Preparation and assembly of the door Building-in Mounting the door Hardwood strip Environment concerns Packaging materialsOld machine Ecological hintsPage 132 963 770-01-302008 Subject to change without notice