DOC. NO. 5956.677.00 P. 1 9 / 3 0
Electrolux
EFS - Dishwashing Systems Platform
Electrolux Professional
Wait about 2 minutes, during which the machine performs a series of air gap filling solenoid valve and rinse
pump activations, until the display will show the actual rinse flow
:
Compare the result obtained with the data given in the table below and if the flow is higher or lower than that
indicated in the table, close or open the rinse flow regulating cock and repeat the control cycle until the opti-
mum value is reached. [Gallons if par. UMU = 1; Litres if par. UMU = 0]
The Rack Type leaves the factory with the cock already adjusted in the optimum position.
The indication of rinse flowrate can be subject to an error of ± 0,3 litres/min.
A4 ACCESSING DATA ON THE CHEMISTRY USED IN THE MACHINE
From the normal machine operation mode it is possible to access the display of Apex low level warnings (rele-
vant to detergent and rinse aid management) and the reading of significant values relevant to the chemistry
used in the machine. To access the Apex data display mode, press at the same time the combination of but-
tons indicated in Figura 7.
MACHINE TYPE CORRECT FLOW (Lit/Min) CORRECT FLOW (Gallons/Min)
WT44 7.2 1.9
WT66 7.2 1.9
Figure 7
Accessing the
APEX INFORMATIONS
rFCEnd 1.9