Electrolux 76640 manual Inlet hose is leaking Connection

Operating Instructions

Problem	Possible Cause	Remedy
	The screw connection on the	Tighten the inlet hose screw
	inlet hose is leaking.	connection
	The drainage hose is leaking.	Check the drainage hose and
		replace it if necessary.
	The washing drain pump	Close cover correctly.
	cover is not correctly closed.
Water runs out from		Stop the programme and re-
	Washing is caught in the	move the washing caught in
under the washing ma-
chine.	door.	the door. Restart the
		programme.
		Close the emergency empty-
		ing hose correctly (see the
	The emergency emptying	section "Carrying out Emer-
	hose is not correctly closed	gency Emptying"). Call your
	or is leaking.	local Service Force Centre if
		the emergency emptying
		hose leaks.
Fabric softener was not	The conditioner insert in the	Clean the detergent dis-
washed in, compart-	compartment for the condi-
		penser drawer and attach the
ment æ for condition-	tioners is not correctly at-
		conditioner insert securely.
ers is filled with water.	tached or is blocked.
		Pay attention to the maxi-
Washing heavily	Probably too much washing	mum load quantity (see Pro-
		gramme tables). In the case
creased	put in the drum.
		of easy-care fabrics, select
		the EASY IRON programme.
The washing has not	The washing was not able to	Always load the drum as ful
been spun as dry as	be distributed evenly in the	as possible with a combina-
usual.	drum prior to spinning.	tion of large and small items.
	Drain hose is kinked.	Remove the kink.
The washing is not suf-		Contact your local Service
	Maximum pump head (dis-	Force Centre. For pumping
ficiently spun. Water is
left in the drum.	charge height 1m from the	heights over 1m a conver-
	appliance's base) is exceeded.	sion kit is available as a spe-
The fault code E20
		cial accessory.
appears . The RINSE
display flashes.		Switch off the appliance and
	Drain pump is blocked.	pull out the mains plug.
		Clean the drain pump.

34