Installation 17
3 | Brown: | Live |
| Blue: | Neutral |
5 |
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
1.Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol 
or coloured green and yellow.
2.Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black.
3.Connect the wire coloured brown to the terminal either marked with the “L“ or col- oured red.
4.Check that no cut, or stray strands of wire is present and the cord clamp 4 is secure over the outer sheath.
5.Make sure the electricity supply voltage is the same as that indicated on the appli- ance rating plate.
6.Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted 
. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely.
Rear spacers
In the bag with the documentation, there are two spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the screw head, then tighten again the screws.
