22What to do if …
Problem | Possible cause | Remedy |
|
|
|
Display changes between two | Power Management is reduc | See the section “ Switching |
heat settings | ing the power of this cooking | the power function on and |
| zone | off” |
| Power Management is active, | Use cooking zones on other |
| maximum load per side | side |
| reached |
|
f flashes | Unsuitable cookware | Use suitable cookware |
|
|
|
| No cookware on the cooking | Put cookware on zone |
| zone |
|
| Diameter of the base of the | Use suitable cookware (min. |
| cookware is too small for the | 120 mm) |
| cooking zone |
|
| Cookware not completely cov | Place cookware centrally over |
| ering cross | the cross |
_ is lit | Overheating protection for the | Switch off the cooking zone. |
| cooking zone has been trig | Switch the cooking zone on |
| gered | again |
| Automatic switch off has been | Switch off the cooking zone. |
| triggered | Switch the cooking zone on |
|
| again |
e and number are displayed | Electronics fault | Disconnect the appliance from |
|
| the electrical supply for a few |
|
| minutes (Take the fuse out of |
|
| the house’s wiring system) |
|
| If after switching on again, e |
|
| is displayed again, call the cus |
|
| tomer service department |
e and minus are displayed | Light rays that are too strong | Briefly shade the control pan |
| on the control panel, for ex | el, for example with the hand |
| ample bright sunlight | Acoustic signal sounds, appli |
|
| ance switches itself off Switch |
|
| appliance on (again) |
|
|
|
If you are unable to remedy the problem by following the above sugges tions, please contact your local Service Force Centre.
1Warning! Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs.
3If the appliance has been operated incorrectly, the visit from the service techni cian or dealer may not take place free of charge, even during the warranty peri od.