Electrolux AOW101E Core probe mode deactivation.Operationis only possible, Microwave Setting

5958 992 00

The oven is equipped with a MULTIPOINT core probe with 6 sen- sors along the entire stem, for correctly measuring the product core temperature even if the tip is not completely in the center.

- Close the door and press the button P3 ( );

5)Stopping the cycle. When the required product core tem- perature is reached the oven stops automatically with the previously described procedure (refer to par. 4.3.7 STOPPING OF COOKING CYCLE) and the elapsed cooking cycle time is shown in a special window (POP-UP).

6)Core probe mode deactivation.(Operationis only possible

with cooking cycle stopped). Set a cooking time on the Timer . This action automatically cuts out the core probe, whereas the op- posite occurs when the time is set.

Core probe mode is also deactivated when the oven is switched off.

4.4.5 SETTING COOKING HUMIDITY

(Only in CONVECTION, COMBI and REGENERATION cooking modes)

Important

When the oven is switched on after several hours of inactivity, wait 20 seconds (the time necessary for stabilization of the LAMBDA probe) for a correct HUMIDITY reading.

After selecting CONVECTION, COMBI or REGENERATION cook- ing mode, press the button P2 to select the % HUMIDITY field and set it as required with knob K.

E.g.

SET COMPARTMENT________________

HUMIDITY 75%I

I CURRENT HUMIDITY___________I

is displayed by the colored zone of the % field (blue 50%)

4.4.6 MICROWAVE SETTING

1)Press the button P2 ( ) several times to select the MICRO- WAVE field and set the required microwave power (500W every level square) with knob K.

E.g.

SET MICROWAVE__________________

POWER 1500W

4.4.7STARTING COOKING CYCLE - MANUAL - make sure the oven door is closed;

- Press the START/STOP button (the message PREHEAT ap- pears)

Preheating is automatic for any set cooking cycle; to skip it press the button P3 ( ) or go to the next point.

- Wait until the compartment temperature field indicates the reach-

EN

ing of preheating temperature (the message LOAD appears) - Open the door and introduce the product to be cooked.

Caution! Risk of burns.

Always open the door with caution when the oven is hot.

- Close the door and press the button P3 ();

The GRAPHIC DISPLAY shows the COOKING IN PROGRESS screen, giving the following information:

DISPLAY OF SET PARAMETERS

recipe or program ________________________

I

I I

phase___________________________

cooking mode____________________

set humidity (100%)____________________100

settemperature(300°F) __________________300

1:00

microwave quantity ____________

set ___________________________________

utility

(timed setting)

80 149

set temperature _____________________________I

(setting with core probe)

DISPLAY OF CURRENT PARAMETERS

To see the CURRENT cooking parameters(displayed in a special

POP-UP window) press the buttonP1 (		).
total remaining time___________________
(58 minutes)*
	HUMIDITY 90%
	COMPARTMENT	100
	TEMPERATURE 126°F	300
Time _______DURATION
elapsed	COOKING 1: 00	0:58
	CORE PROBE

TEMPERATURE 75°F

CURRENT PARAMETERS______

P1

(timed setting)

current temperature _______________

80 149

(80°F "27°C")

(setting with core probe)

(*) The time remaining for the end of the entire cycle, 58 minutes in this case. In fact, the countdown for the cooking time is carried out.

27