EN
Replacing door seals (Fig. 4)
NB: The door seal is a component that can become worn over time. It is advisable to replace it whenever any hardening or break- age is noticed.
To replace it, proceed as follows:
•Remove the seal from its seat and clean the latter of any traces of silicone.
•apply a bead of silicone sealant at point 1 along the inside pro- file of the seal seat.
•insert the new seal along the entire seat.
9.3 PARTICULAR CLEANING
Cleaning and checking efficiency of the draining system Periodically clean the drain pipe, checking for any obstructions involving the draining of water.
Cleaning the CLEANING SYSTEM rotating jet (Fig. 5) It is advisable to clean the jet in case of:
-long periods of CLEANING SYSTEM disuse
-difficulty in wash arm rotation (probable nozzle obstruction)
-use of very hard water.
If the nozzles are completely obstructed, use the tip of a knife to remove any encrustations.
•Extract (without removing) the retaining clip A from the middle block of the jet. For this operation, insert the tip of a screwdriver in the part indicated by the arrow and turn it from the vertical to the horizontal position as shown in the figure.
•Remove the jet from the rotation pin.
4
5
•Place the rotating jet in a bowl containing descaler, leave to work over night then rinse with plenty of water.
•Refit the jet, inserting it on the rotation pin and pressing the retaining clip into its original position.
5958 992 00
34
