Instructions for the user
8.5Cleaning the igniter plugs and thermocouples
In order for the igniter plugs and thermocouples to operate correctly, they must be kept clean at all times. Check them frequently and, if necessary, clean them with a damp cloth. Any dry residue should be removed with a toothpick or needle, taking care not to damage the insulating ceramic part.
8.6Cleaning the ceramic hob
The ceramic hob must be cleaned regularly, each time it is used if possible, when the latent heat lights are off.
Any
Any burnt residue left after cooking can be removed with a wooden spatula. Rinse with water and dry well with a clean cloth.
Do not under any circumstances use abrasive or corrosive detergents (e.g. powder products, oven sprays,
Any grease deposits on the ceramic hob can be removed more easily by heating it for approximately
The cooking surface of the ceramic hob is extremely resistant. It is not however unbreakable and may be damaged, above all by pointed or hard objects if dropped onto it with a certain force. Do not use the ceramic hob if the surface is broken, cracked or split! Contact your local Service Force Centre immediately.
8.7Cleaning the oven
Clean the oven regularly, each time it is used if possible, after leaving it to cool: in this way it is possible to remove any residue more easily, preventing it from burning the next time the oven is used.
Clean the stainless steel parts and enamelled parts as described in the corresponding sections “8.1 Cleaning stainless steel surfaces” and “8.2 Cleaning enamelled surfaces”.
Take out all the removable parts and wash them separately. Rinse and dry thoroughly with a clean cloth.
8.7.1Cleaning the oven door
We recommend always keeping the oven door clean. Use kitchen roll and on tougher dirt use a damp cloth and household detergent.
Spray products for cleaning the oven must not be used to clean the fan and the thermostat sensor inside the oven compartment.
20
