Electrolux D2160-1 operating instructions Fitting Into The Cabinet

Models: D2160-1

1 40
Download 40 pages 25.81 Kb
Page 38
Image 38
FITTING INTO THE CABINET

FITTING INTO THE CABINET

IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.

Using a tape measure establish the internal width of the cabinet. Refer to page 33 if greater than 565mm.

Position the appliance in front of the cabinet. See Fig. 8.

Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.

To place the appliance into the cabinet follow the procedure below:

N.B. Two people will be required to carry out the lifting procedure.

Warning: Do not attempt to lift this appliance by the handle(s).

Each person should squat either side of the appliance.

Tilt the appliance so that your hands can support the underside of the appliance.

Keeping your back straight, raise the appliance to the cabinet by straightening at the knees.

Rest the rear underside of the appliance on the cabinet floor while your hands support the front.

The appliance can be pushed fully into the cabinet. Take care to avoid damaging the mains lead.

Ensure the appliance is central in the cabinet and level.

Do not remove spacer fitted behind fixing holes.

When the appliance is fully housed screw the stability screws (supplied with the appliance) into the side of the cabinet taking care not to distort the side trims (See Fig. 9). It is advisable to turn each screw alternately to avoid damaging the trims.

Switch on the appliance then refer to the operating instructions.

Fig.8

(Cable not supplied)

Fig.9

COMPETENCE D2160-1- 311568109

38

Page 38
Image 38
Electrolux D2160-1 Fitting Into The Cabinet, Warning Do not attempt to lift this appliance by the handles