CLEANING THE DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following:
Household detergents and bleaches Impregnated pads unsuitable for
Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols
lRust removers Bath/Sink stain removers
The main oven and second oven inner door glass panels are removable for cleaning.
TO REMOVE THE INNER GLASS
1.Fully open the oven door.
2.Firmly grasp the rear edge of the inner glass panel with both hands.
3.Push the glass panel towards you until it clears the hinge location points at the rear.
4.With one hand, carefully lift the glass panel to disengage it from the location points under the handle. (With your other hand, hold the outer door to ensure it does not spring shut on removing the inner panel).
5.Close the oven door.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Centre who will be pleased to advise further.
TO CLEAN THE INNER GLASS DOOR PANELS
Clean the inner door glass panels using a soft cloth and hot water to which a little washing up liquid has been added. If the inner panel is heavily soiled, Hob Brite may be used. Do not use abrasive cleaning materials on the door glass. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the glass.
Do not clean stainless steel outer panels (where fitted) with Hob Brite as damage to the finish will occur. See cleaning instructions for stainless steel models on page 23.
Hinge location point
Hinge location point
24
