Electrolux 251, D250, 95390024300, 95390024400 Prior to use, Apparel, Health precautions, Work zone

	Danger of flying debris.
15 m	Minimum safety distance 15m.
	Emergency stop.
	Maximum shaft speed.

Danger of kickback. The blade is capable of amputating arms and legs.

CAUTION!

Danger of serious leg injuries. Take scrupulous care to follow the instructions in the manual.

CAUTION!

The cutting parts and muffler may get very hot and cause burns. Wait a few minutes before touching them.

Prior to use

•Do not use this machine for any other purpose than that for which it was designed, using the proper cutting devices as indicated in the instructions.

•B1. Anyone who uses the machine should have read the entire manual with extreme care.

•Make sure you know how to stop the engine and blade if necessary (see section entitled “Starting and stopping the engine”).

•All users should be familiar with the operations for use of the machine under absolutely safe conditions as described in this manual, and should be instructed in the proper cutting techniques to use, possibly by practical demonstration.

•Do not use the machine if you are tired, in poor health or under the effects of alcohol or medication that could affect your reactions.

•Do not allow children or persons who are not familiar with these instructions and are not sufficiently trained to use the brush cutter. Local regulations may specify an age limit for users.

•Keep this manual with the machine when selling or lending it, to enable the future users to familiarize themselves with the product and instructions for safe use.

•Always inspect the machine carefully prior to use: make sure it is correctly assembled and that there are no loose screws, damaged parts, fuel leaks.

•Replace any accessories (blades, nylon string heads, guards) which show damage or cracks or appear excessively worn. Have your Authorized Service Center replace any damaged parts.

•Perform all operations of maintenance and/or assembly ONLY with the engine off and wearing gloves.

Apparel

•B2. Dress suitably for the job; wear approved personal protection gear: a) Close-fitting clothing (no shorts or loose clothes). b) Safety boots with non-slip sole, crush-resistant toe cap and protection against cuts (do not wear sandals or work barefoot). c) Sturdy gloves

2 - ENGLISH

resistant to cuts and vibrations. d) Safety visor or protective goggles. Remove the protective film if any. e) Hearing protection. The use of personal protection gear does not eliminate the risk of injury but may reduce the effect of the damage in case of accidents.

•Do not wear loose clothing or jewelry that could get caught in the moving parts of the machine.

•Watch out for the rotating parts and hot surfaces of the machine.

Health precautions

￿CAUTION! Avoid prolonged use. Noise and vibrations may be dangerous.

•Prolonged use of the machine or other equipment expose the operator to vibrations that can cause the White Finger Syndrome (Syndrome of Raynaud). This could reduce the sensitivity of the hands in distinguishing different temperatures and cause a general numbness. The operator should therefore check the conditions of the hands and fingers if the machine is used continuously or regularly. If one of the symptoms should appear, consult a doctor immediately.

•Prolonged use of the machine or other equipment can cause discomfort, stress, fatigue, hearing damage. Wear suitable hearing protection when using the machine. Correct and scrupulous maintenance can also help to protect you further from the risk of noise and vibration.

•Never start or run the engine in a closed or poorly ventilated place.

￿CAUTION! The exhaust fumes are toxic if inhaled, and may cause asphixiation and even death.

Work zone

•Examine the work area and be careful of any hazards (such as roads, driveways, power lines, hanging tree limbs, etc.).