Electrolux EFC650, EFC950, EFC9405, EFC9410, EFC6410 Wall unit mounting - Fig, Ø 120mm, Installation

Installation

Wall unit mounting - Fig. 8

• Put the template onto the wall (1) and drill two Ø12mm holes (2).
• Fit two hooks (3) on the drilled holes.
• Remove the metal filters (4) and hang the hood on the hooks and adjust the position of the hood using the two
	screws on the bottom of the hooks (5).
• Mark 2/4 points (6). Remove the hood and drill 2/4 Ø8mm holes on the marked points.
	Fit 2/4 Ø8mm wall dowels, Hang again the hood and fix the hood definitively with 2/4 screws 5X45 (7).
• Fix the chimney support (8) with two screws 5 x 45 mm and two wall dowels on the wall close to the ceiling.
• For exhausting version: Fit the connection ring (S) on the top of the hood with two screws Ø 3,5 x 6,5 mm
	(9S) then fit an axhausting pipe long enough to reach the outside (10S).
	For recycling version: Fix definitively the deflector				(K) on the top of the hood with two screws Ø 3,5 x 6,5
	mm (9K).
• Prepare the electric connection (11) (see relative chapter).
• Fit the chimney (12) and fix it on
	the chimney support with two
	screws 3,0 x 9 mm (13).
	The lower part of the chimney						8
	must be slided down and inserted							13
	on the housing on the upper part of
	the hood (14).				13
•	Fit the two grids (15) on both
	sides of the chimney.				11		12
									15
	6		6
							15	14		14
						7
		3	2	3			7
					6	4
				4
	6							7
	1		7
								4
				4					Ø 120mm
	5							10S
			9K	9K
	K							S	9S
					9K	9K		9S
					9S		9K	9K

Fig. 8

39