Electrolux EHD90LLUM Installation instructions, Cutting the benchtop out, Pull down clamps

20installation instructions electrolux induction cooktop

Installation instructions

Cutting the benchtop out

•The bench cutout needs to be sized by using the supplied template.

•A cutting accuracy of 1.5mm either side of the marked area needs to be maintained.

Pull down clamps

• These are supplied in a parts bag consisting of 4 clamps and 4 screws.

• The clamps should be pre-assembled onto the 4 brackets before dropping the unit into the cutout.

Rubber seal

• An oversized length of rubber seal is supplied in the parts pack

• This should be pushed into the recess on the underside of the frame. The join should lie in the middle of one side.

• The seal will have to be cut to length (add a few mm) and then the two ends pushed up against one another.