29
Changing The Filter

More about your advanced water filter

The PureAdvantageTM ice and water
filter system is tested and certified
byNSFInternational,thenationally
respected, not-for-profit certification
organization for public health safety.
The PureAdvantageTM ice and water filter system
istestedandcertiedtoANSI/NSFStandards42
and 53 for the reduction of claims specified on
the performance data sheet.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable
cysts.

Test & certification results:

 • RatedCapacity-400gallonsfor
PureAdvantageTM ice and water filter
 • Ratedserviceow-.5gallonsperminute
 • MaximumRatedPressure-100pounds
per square inch
 • OperatingTemp.:Min.33°F,Max.100°F
 • RecommendedMinimumOperating
Pressure: 30 pounds per square inch
6 Press a drinking glass against the water
dispenser while checking for any leaks at the
lterhousing.Anyspurtsandsputtersthat
occur as the system purges air out of the
dispenser system are normal.
7 Afterllingoneglassofwater,continue
flushing the system for about three minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button on
the Ice & Water Dispenser control panel for
three seconds. When the display changes
from “Replace” to “Good,” the status has
been reset.
To replace your PureAdvantageTM water

filter:

It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the filter
replacement.
1 Turn Off the ice maker power switch.
2 Push the filter release button below the
cartridge to disconnect it.
3 Slide the old water filter cartridge straight out
of the housing and discard it.
4 Unpackage the new filter cartridge and slide
it gently into the filter housing until it stops
against the snap-in connector at the back of
the housing.
5 Push firmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
When fully engaged, the front of the filter
cartridge should be flush with the filter
release button.