1.Check that
–the pan or
–the pan or
2.Place a pan or
3.Choose the desired setting with 
or 
. Remember that the pan heats up much faster than on an ordinary hob.
4.Turn off the hob after use.
The zones share the heating effect
NOTE that when the left or the right induction zones are switched on at the same time, they share the heating effect. This is shown by a clicking sound from the hob and the fact that cooking may possibly increase and de- crease.
The reason is that they share the same en- ergy source. In order to utilise the maximum top effect (booster) on a zone, then the effect
electrolux 9
of the other zones must be reduced (this is done automatically).
It is possible to use both zones at the same time, even with one set on booster. BUT RE- MEMBER that one zone has a reduced ef- fect, which means a longer cooking time. In the case of other settings, you will not notice any great difference, no zone has priority over the others.
A certain sound can occur when using cer- tain pans.
A simple induction principle
When a current passes through a coil, it cre- ates a magnetic field. Under a heating zone there is a coil fitted with ferrite rods. When a pan (with a magnetic bottom) is placed on the zone, the coil and rods create an almost closed magnetic system. The energy pro- duced heats up the pan and its contents.
Operating the Touchpanel
Touch Control sensor fields
The appliance is operated using Touch Con- trol sensor fields. Functions are controlled by touching sensor fields and confirmed by dis- plays and acoustic signals. Touch the sensor fields from below, without covering other sensor fields.
Digital display
Each of the cooking zones has a display which shows:
•
that the hob is switched on
•
selection of heat retention setting
•
, the selected position
•
Automax
•
Booster
•
residual heat
Switching the appliance on and off
•
that the
•
Faulty
•
Cookware is unsuitable or too small or no cookware has been placed on the cooking zone
Residual heat indicator
Warning! Warning! Risk of burns from residual heat. After being switched off, the cooking zones need some time to cool down. Look at the residual heat indicator 
.
Residual heat can be used for melting and keeping food warm
Switch on
Switch off
Control panel
Touch 
for 2 seconds
Touch 
for 1 second
Display
/ 
/ none
Pilot light
lights up
goes out
After switching on, within approx. 10 seconds a heat setting or a function
Setting the heat setting
Control panel
To increase | Touch |
|
|
must be set, otherwise the appliance au- tomatically switches itself off.
Indicator
to 
