electrolux 29
Adaptation to different types of gas
IMPORTANT
The adaptation to different
types of gas should only be
undertaken by a competent and
qualified engineer.
It is important to note that this model is
designed for use with natural gas but can
be converted for use with LPG providing
the correct injectors are fitted. The gas
rate is adjusted to suit.

Replacement of gas oven

burner injector

To replace the gas burner oven injector,
follow this procedure:
1. Remove the bottom plate of the oven
cavity (“A”) to access the gas oven
burner (“B”).
2. Undo the two fixing screws (“C”) which
keep the gas oven burner in place.
3. Gently slide the oven gas burner off
the injector support (“D”) and slowly
move it to the left hand side. Check
that the burner bush does not slip off
the burner mouthpiece, and take care
not to cause stress to the spark candle
connection wire (“E”) and the
thermocouple conductor (“F”).
4. With a 7 mm socket spanner unscrew
and remove the gas burner injector
(“D”), and replace it with the required
one (see Table on the following page);
5. Reassemble the burner following the
same procedure backwards.
6. Replace the gas type sticker (it is
located near the gas connection
ramp) with the one relevant to the new
gas type which is supplied with the
injector kit.
The oven burner does not require
any primary air regulation.
D
F
E

D

E

F