Electrolux EON 30620 user manual To perform this operation correctly, proceed as follows

6)place the door on a stable surface (Fig. 12) protected by a soft cloth to prevent the handle surface from being damaged;

7)release the locking system to remove the internal panes of glass (Fig. 13);

8)turn the 2 fasteners 90° and extract them from their seats (Fig. 14);

9)gently lift and carefully take off the upper- most pane marked by a decorative frame on 4 sides (Fig. 15).

Clean the oven door with lukewarm water and a soft cloth. Do not use products such as scouring pads, steel wool, abrasive sponges or acids because they could damage the special heat-reflecting surface of the internal panes of glass.

After cleaning, reassemble the panes in the door and then the oven door, following the procedure described above in reverse. Make sure you reposition the panes correctly.

To perform this operation correctly, proceed as follows:

-the decorated internal pane with a frame on the 4 sides must be reassembled so that the screen-printing is facing outwards. The side of the pane of glass is correct if you do not feel any roughness near the screen printing when you pass your fingers over the surface.

Fig. 12

Fig. 13

90°

Fig. 14 electrolux 47