electrolux integrated barbecue gas specifications/natural gas installation 3
Gas specifications | Natural Gas installation |
gas type | natural gas | universal LPG |
Maximum gas consumption | 50 MJ/hr | 50 MJ/hr |
Injector orifice diameter | 1.75mm | 0.95mm |
Number of injectors | 4 | 4 |
Regulator pressure | 1.00 kPa | 2.75 kPa |
NOTES
såå
så 4HISåPRODUCTåISåINTENDEDåFORåOUTDOORåUSEåONLY
så 4HISåPRODUCTåMUSTåBEåINSTALLEDåASåPERåTHEåINSTRUCTIONSå
which requires the installation of venting to enable the barbecue to operate correctly. Failure to provide adequate ventilation for supply of air to the appliance may result in poor burner performance or excessive heat
så 6ENTILATIONåHOLESåINåTHEåUNITåMUSTåNOTåBEåOBSCUREDåBYå the installation.
Preparing the unit for Natural Gas installation
This barbecue is supplied set up for Natural Gas and is labelled accordingly. A Universal LPG conversion kit is included if required. Conversion of this unit to Universal LPG must be carried out by a qualified licensed person.
A Certificate of Compliance must be issued to the owner on completion of the installation and conversion.
Fit Natural Gas installation pipe to the barbecue gas inlet to enable access to the regulator in the installed position. When tightening the regulator or any other connection do not
1. Fitting the Natural Gas installation pipe
åsåå&ITåTHEåPIPEåENSURINGåTHEåBLUEåSEALINGåWASHERåISåINå place. Do not
2. Fitting the regulator
åså &ITåTHEåREGULATORåENSURINGåTHEåBLUEåSEALINGåWASHERå is in place and the arrow indicating gas flow is
correct. Do not
åså !PPLYåTHREADåTAPEåORåSEALANTåTOåTHEåMALEåTHREADåONå the hose and screw into the regulator. Do not over- tighten.
Gas connection detail
137mm |
408mm |
46mm |
barbecue gas inlet
sealing washer
Natural Gas installation pipe
sealing washer
regulator – ensure arrow is pointing in the right direction
hose with tapered thread – thread tape required
4. Fit to mains
åså #ONNECTåTHEåBAYONETåENDåTOåMAINS
Preparing the unit for Natural Gas connection to mains
For Natural Gas connection a bayonet connection point should be installed by a licensed gas fitter prior to installing the barbecue unit.
