Electrolux ERES3500X Service during operation, Defrosting the fridge, To change the light bulb

Models: ERES3500 ERES3500X

1 20
Download 20 pages 58.47 Kb
Page 10
Image 10
Service during operation

Service during operation

The water filter is replaced as follows:

Place a piece of kitchen tissue or a dishcloth in the space under the filter. Remove the filter by turning it clockwise. A small amount of water will run out. Dry off and fit the new filter.

See the section "When starting the water system for the first time".

The water connection does not need to be switched off when changing the filter.

Replacement filters can be ordered from Electrolux Service Force Centre. See the section "Service and spare parts".

The gas cylinder is replaced as follows: remove the gas cylinder and move over the adapter to the new cylinder. The replacement gas cylinder is obtained through your local dealer.

Defrosting the fridge

The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented by:

·not putting warm foodstuff inside the cabinet.

·avoiding frequently opening the door or keeping it open too long.

To change the light bulb

The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet.

Cut the packaging around the bulb socket.

Keep the packaging on to hold the bulb when setting it into the socket. Do not touch the bulb with your bare fingers. Halogen light bulbs are sensitive to grease from the skin.

Use a clear, UV-blocked, low-pressure type halogen light bulb. Socket G4. Voltage 12 V. Power rating 20 W/bulb.

Installation of carbon filter

To maintain the best performance the carbon filter should be changed once a year with normal usage. New carbon filters can be purchased from your local dealer. The filter is placed behind the grill and can be reached by opening the cover. The cover can be opened by simultaneously pressing the lever on the right of grill (1) and turning the cover outward (2). The carbon filter is then pulled out of its slot (3). The new carbon filter is placed in the existing slot - The filter should be handled carefully so fragments don't loosen from the surface.

When the appliance is not in use

Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.

If the appliance is left on, e.g. while on holiday, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.

G4UV-blocked

20W/12V

Low pressure

 

1

2

3

Electrolux 8183823-00/7

10

Page 10
Image 10
Electrolux ERES3500X manual Service during operation, Defrosting the fridge, To change the light bulb