Electrolux ERES3500 Something Not Working, Symptom, Solution, is displayed in the temperature

Something Not Working

Before contacting your local Service Force Centre check the following points:

Symptom	Solution
"￿" is displayed in the temperature	An error has occurred in measuring the temperature. Call your
display.	service representative. (The cooling system will continue to
	keep food products cold, but temperature adjustment will not
	be possible.)
The temperature is too high inside the	Set a lower temperature.
refrigerator.	Put food products in the right place inside the refrigerator. See
	the chapter "Temperature inside the refrigerator".
	Distribute the food products to allow cold air to circulate
	around them.
	Make sure that the door is completely closed and that the
	rubber door seal is complete and clean.
It is too cold inside the refrigerator.	Set a warmer temperature.
Water comes out on the floor.	Place the drain hose at the back of the appliance above the
	drain bowl. See the chapter "Before use"
The compressor operates continuously.	Set a warmer temperature.
	Make sure that the door is completely closed and that the
	rubber door seal is complete and clean.
The cabinet does not operate at all.	Power does not reach the appliance. (Try connecting another
Cooling or interior light does not	electrical device to the power outlet.)
operate. No indicator lamps light.	The appliance is not switched on.
	The fuse has blown.
	The power plug is not properly connected.
Noise	The refrigerating system will always produce some sounds. A
	pulsing sound is heard when coolant is pumped inside the
	cooling pipes. A ticking sound from the thermostat can be
	heard when the compressor switches on and off. The sound
	level varies depending on the operation of the cabinet.
	If you feel the sound level is incorrect:
	Make sure the pipes at the back of the cabinet not touch each
	other. Carefully bend them if they do.
	If the cushion spacers (between the cabinet wall and pipes)
	come loose, put them back in place again.
	Carefully follow the instructions in the chapter "Installing the
	cabinet".
Not enough carbon dioxide in the water	Incoming water pressure too low.
	Drain off a large amount of carbonated water (about 1 litre)
	The carbon dioxide is running out. Replace the gas cylinder.
	Storage temperature too high. Lower the temperature in the
	refrigerator.
Too much carbon dioxide in the water	Dilute with ordinary water. (See the section "The water
	dispenser functions")
No carbon dioxide.	The gas cylinder is empty. Replace the gas cylinder.
	Drain off a large amount of carbonated water (about 1 litre)
	Incoming water pressure too low.
	Electrolux 8183823-00/7

11