14electrolux
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the dishes.
There are streaks, milky stains, or a bluish layer on glasses and dishes.
Dry water drop stains on glasses and dishes.
The dishes are wet.
The dishes are wet and dull.
Possible cause
The selected washing pro- gramme was not applicable for the type of load and soil.
The baskets were not loaded correctly, water did not touch all surfaces.
The spray arms could not turn freely because of incorrect ar- rangement of the load.
The filters are dirty or not as- sembled and installed correctly.
The quantity of detergent was not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust- ment
The salt container cap is not closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause.
You have set a washing pro- gramme without drying phase or with a decreased drying phase.
The rinse aid dispenser is emp- ty.
Possible solution
Make sure that the washing programme is applicable for the type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar- rangement of the load does not cause a blockage of the spray arms.
Make sure that the filters are clean and correctly assembled and installed.
Make sure that the quantity of detergent is sufficient.
Fill the salt container with dish- washer salt.
Adjust the water softener.
Make sure that the salt contain- er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of deter- gent.
Let the door stay ajar for some minutes before you remove the dishes.
Fill the rinse aid dispenser with rinse aid.
TECHNICAL DATA
Dimensions
Water supply pressure
Water supply 1)
Capacity
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
600 mm
850 mm
610 mm
0.5bar (0.05 MPa) 8 bar (0.8 MPa)
maximum 60 °C
12
1) Connect the water inlet hose to a water tap with a 3/4'' thread.