Electrolux ESI 6220 manual there are problems operating the dishwasher, The dishes are still dirty

...there are problems operating the dishwasher.

Symptom	Possible Cause	Solution
	The dishwasher door has not been closed	Shut the door.
	properly.
The programme does	The mains plug is not plugged in.	Insert mains plug.
not start.	House fuse is faulty.	Replace fuse.
	For dishwasher models with delay start	If dishes are to be washed immediately
	timer: Delay start has been selected.	cancel delay start timer.
	The washing compartment is made of anti-	Only wash cutlery and dishes that are
	corrosive stainless steel. Any spots of rust	suitable for dishwasher use.
Spots of rust are visible	inside the washing compartment stem from
in the washing compart-	other sources (flakes of rust from the water
ment.	pipe or from pans, cutlery etc.) Remove	Close the salt dispenser lid securely.
	such spots with a commercially available
	stainless steel cleaner.
There is a whistling	The whistling is not a cause for concern.	Use a different brand of detergent.
noise during washing.

...the wash results are unsatisfactory.

The dishes are still dirty.

•The wrong wash programme was selected.

•The dishes were arranged in such a way as to stop the water reaching all parts of the surface. The dish racks must not be overloaded.

•The filters in the base of the washing compart- ment are dirty or incorrectly positioned.

•Too little or no detergent was used.

•Where there are limescale deposits on the dishes: The salt dispenser is empty or the water softener unit is set wrongly.

•The drain hose is incorrectly connected.

The dishes are wet and dull.

•Rinse aid was not used.

•The rinse aid container is empty.

There are streaks, milky spots or a bluish coating on glasses and dishes.

•Decrease rinse aid dosing.

There are dried water drops on the glasses and dishes.

•Increase rinse aid dosing.

•The detergent may be the cause. Contact the detergent manufacturer's consumer advisor.

23