Electrolux ESI 6220 manual Water inlet hose with safety valve

3The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap:

Water inlet hose with safety valve

After connecting the double-walled water inlet hose, the safety valve is next to the tap. Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water and the draining pump in the dishwasher is switched on.

1Please take care when installing the water inlet hose:

–The distance between the bottom edge of the safety value and the floor on which the dish- washer is standing must be at least 30 cm:

–The electrical cable for the safety valve is in the double-walled water inlet hose. Do not immerse the water inlet hose or the safety valve in water.

–If the water inlet hose or the safety valve is damaged, remove the mains plug immediately.

–A water inlet hose with safety valve must only be replaced by a specialist or Customer Serv- ices.

–Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve.

30