Problem
Limescale particles on the dishes.
There are streaks, whitish stains, or a bluish layer on glasses and dishes.
Dry water drop stains on glasses and dishes.
The dishes are wet.
The dishes are wet and matt.
Possible cause
The spray arms could not turn freely. Incorrect position of the items in the baskets.
The filters are dirty or not as- sembled and installed correctly.
The quantity of detergent was not sufficient or missing.
The salt container is empty.
Incorrect level of the water soft- ener adjustment.
The salt container cap is not closed correctly.
The rinse aid quantity is too high.
The rinse aid quantity is too low.
The detergent can be the cause.
The washing programme was without a drying phase or with a decreased drying phase.
The rinse aid dispenser is emp- ty.
The multitab function is on (this function automatically deacti- vates the rinse aid dispenser).
electrolux 15
Possible solution
Make sure that an incorrect po- sition of the items do not cause the blockage of the spray arms.
Make sure that the filters are clean and correctly assembled and installed.
Make sure that the quantity of detergent is sufficient.
Fill the salt container with dish- washer salt.
Adjust the water softener with the correct level.
Make sure that the salt contain- er cap is closed correctly.
Decrease the rinse aid quantity.
Increase the rinse aid quantity.
Use a different brand of deter- gent.
For better drying results, keep the door ajar for some minutes.
Fill the rinse aid dispenser with rinse aid.
Activate the rinse aid dispenser.
Activating the rinse aid dispenser
1.Activate the appliance.
2.Make sure that the appliance is in set- ting mode.
3.Press and hold buttons (4) and (5) at the same time until the indicators of buttons (3), (4) and (5) flash.
4.Release buttons (4) and (5).
5.Press button (4).
•The indicators of buttons (3) and (5) go off
•The indicator of button (4) continues to flash
•The display shows the setting of the rinse aid dispenser.
Rinse aid dispenser is off.
Rinse aid dispenser is on.
6.Press button (4) to change the setting.
7.Deactivate the appliance to confirm.
TECHNICAL DATA
Dimensions |
| Width |
|
| Height |
|
| Depth |
Water supply pressure |
| Minimum |
|
| Maximum |
|
|
|
446 mm
818 - 898 mm
550 mm
0.5bar (0.05 MPa) 8 bar (0.8 MPa)
