Malfunction
The programme does not start
electrolux 19
Possible cause and solution
•The dishwasher door has not been properly closed.
Close the door.
•The main plug is not plugged in. Insert the main plug
•The fuse has blown out in the household fuse box.
Replace the fuse.
•Delay start has been set.
If dishes are to be washed immediately, cancel the delay start.
Once these checks have been carried out switch on the appliance and close the door. The programme will continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact your local Service Force Centre. For other fault codes not described in the above chart, please contact your local Serv- ice Force Centre.
Contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher door.
So that you always have these numbers at hand, we recommend you to make a note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a blu- ish coating on glasses and dishes
Water drops have dried onto glasses and dishes
The wash results are not satisfactory
•The wrong programme has been selected.
•The dishes are arranged in such a way as to stop water reaching all parts of a surface. The baskets must not be overloaded.
•The spray arms do not rotate freely due to incorrect arrangement of the load.
•The filters in the base of the washing compartment are dirty or incorrectly positioned.
•Too little or no detergent has been used.
•Where there are limescales deposits on the dishes; the salt container is empty or incorrect level of the water softener has been set.
•The drain hose connection is not correct.
•The salt container cap is not properly closed.
•Rinse aid was not used.
•The rinse aid dispenser is empty.
•Decrease rinse aid dosage.
•Increase rinse aid dosage.
•The detergent may be the cause. Contact the detergent manufacturer con- sumer care line.
If after all these checks, the problem persists, contact your local Service Force Centre.
Technical data
Dimensions | Width cm |
| Height cm |
|
|
44,6
81,8 - 89,8
