10 | Use | F4VA1 |
|
|
|
The higher the value displayed by gauge (15), the lower the tension on the sleeves. To adjust the tnesion, pull knob (20) and turn to change the value displayed. Push the knob to lock the value**.
Sleeve arms
(16)is correct*. Otherwise, pull knob (19) and rotate to adjust the pressure. When finished, push knob in to lock in position.
Antistretch exclusion: To exclude the antistretch, push the button (L) on the console prior to starting a cycle. When the button is pushed in, the side expanders keep stretching the shirt during the cycle. When the button is released out the antistretch feature is activated, that is, it prevents the side expanders from ovestretching the fabric.
Carriage down button: Push and hold button (M) on the console to lower the carriage. This feature allows to manually increase vertical tension during the cycle.
See the next chapter “Use of the control board” to learn how to program pressing cycles and to discover the power of the control board.
*The recommended value is 4 bar. ** The recommended value is 2 bar.
4.6.1. Adjusting sleeve arms height
1.Loosen the knob located on the sleeve arm
2.Slide the topper part of the arm to the desired height
3.Tighten the knob
