12 | Use of the control board | F4VA1 |
|
|
|
5.5. MANUAL CONTROLS section
AIR Press once to start blowing. Press it again to stop blowing. In order to have manual MIX press STEAM during the blowing operation.
REPEAT CYCLE Repeats the cycle without further tensioning; this but- ton is enabled only at end of the pressing cycle and only if the MANUAL END mode is selected.
END CYCLE Ends the cycle immediately, interrupts all ongoing com- mands, opens all clamps. When the MANUAL END mode is selected, press this button to open the clamps at the end of the cycle.
STEAM Keep pressed to steam the shirt.
BACK CYCLE Use this button to undo the last step in the dressing sequence.
5.6. Operating MODE
The Mode section consists of 3 buttons with green LED.
To select a mode press the relative button: the green LED turns on.
5.6.1. Button 
When the LED is ON: the side clamps (10 - Figure 4.3) close at the beginning of the cycle and open automatically after the time programmed in the H03 parameter (see table 5.2). This mode is useful for thick fabric or low extraction, because closed clamps may hinder proper drying of the area.
When the LED is OFF: the side clamps stay closed during the whole cycle.
The button has no function if the side clamps are excluded (param- eter H05 = 00).
5.6.2. Button 
The MANUAL END function is utilized when it is necessary to verify garment pressing quality at the end of a cycle.
When the MANUAL END function is active (the green LED of the but- ton “MANUAL END” is on), the clamps remain are not released at end of the cycle.
This allows to:
•run another cycle by pushing REPEAT CYCLE
•manually steam and blow the garment with buttons AIR and
STEAM
•manually touch up the garment with the iron (if mounted on
your machine).
When the garment is properly finished, end the cycle and open the clamps by pressing the “END CYCLE” button (in the “manual con- trols” section).
5.6.3. Button 
The button is not active.
