What to do, if...
Try to rectify minor faults on the dishwasher with the aid of the instructions given here.
...a flashing fault code appears
an audible signal informs you that an alarm has been activated, in the display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 - AL5 - AL6 - AL7 and the indicator light of the phase under way is flashing. They are indicative of a fault in the dishwasher that you can probably rectify yourself.
-Press the ON/OFF push button to switch the dishwasher off.
-Open the door and carry out the following suggested corrective actions.
Fault code
"DOOR" indicator light flashes
"WATER" indicator light flashes and/or alarm AL5
Alarm AL6
Alarm AL4
Alarms AL1 - AL2 - AL3 - AL7 - AL8
Possible cause
The door has not been properly closed.
The water tap is closed.
The mains water supply has been cut off.
The inlet hose may be squashed or bent.
The inlet hose may be blocked.
The drain hose may be squashed or bent. The drain hose extension is not correct.
The sink may be blocked.
Protection against flooding is active.
General
Remedy
Close the door.
Open the water tap.
Wait for the supply to be restored.
Reposition correctly the hose.
Switch off the water supply and clean the filter.
Reposition correctly the drain hose. Follow the instructions for connecting to the waste.
Clear any blockages.
Close the water tap and contact the Service Force Centre.
Switch off the dishwasher, switch back on and start a wash programme. If the fault code reappears contact the Service Force Centre.
30
Once you have checked the possible causes listed above, switch on the dishwasher and start a wash programme, if the fault code reappears contact the Service Force Centre.
