Section 10 Reference Information

Error Code Tables

When a communications error occurs, one of the following error codes will be printed out on the corresponding Transmission Report or Reception Report as well as the Activity Report.

Refer to the following tables for a more detailed explanation of the error.

* If an error occurs during communication at a transmission speed of 33600 bps, the “U” in the error codes noted below will change to an “E”.

CODE

CAUSE AND/OR PROCEDURE FOR CORRECTION

 

 

Busy

The line is busy or the other party does not answer after automatically redialing the set number of times.

 

Perform transmission or reception procedures again.

 

 

Stopped

Transmission has been interrupted by pressing the Stop/Clear key.

 

Reception has been interrupted by pressing the Stop/Clear key.

 

During multiple communication (Broadcast Transmission, Polling Reception, etc.), this unit was unable to

 

transmit to all destinations due to a communications interruption.

 

 

U00300

The destination FAX has run out of recording paper. Check with the destination party.

 

 

U00420 - U00462

Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted

 

because the transmitting party does not possess the necessary communication capabilities.

 

 

U00600 - U00690

Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures

 

again.

 

 

U00700

Communication was interrupted due to trouble with the other party’s FAX unit. Check with the other party.

 

 

U00800

Unsuccessfully transmitted page(s) remain. Perform transmission procedures again.

U00810

 

 

 

U00900

Unsuccessfully received page(s) remain. Perform reception procedures again.

U00910

 

 

 

U01000 - U01092

A communication error occurred during transmission. Perform transmission procedures again.

 

 

U01100 - U01199

A communication error occurred during reception. Perform reception procedures again.

 

 

U01400

A communication which uses the timer was scheduled, and a number was entered using an abbreviated number

 

or one-touch key, etc., but communication with that party was impossible because that number was no longer

 

registered when the scheduled time arrived. Check your unit.

 

Or, communication with that party was impossible because the number included a pound sign (#) and it was

 

registered with the Line Type setting set to “Tone Line”, but the Line Type setting had been changed to “Pulse

 

Line” at the time you attempted that communication.

 

 

U01500

A communication error occurred during transmission at high transmission speed. Perform transmission

 

procedures again.

 

 

10-7

Page 191
Image 191
Xerox FAX System (J) manual Error Code Tables, Code Cause AND/OR Procedure for Correction