Xerox FAX System (J) manual Tx.Press the Memory TX key until it changes to Dir. Feed

Section 3 Fax Operation (Various Functions)

Sending Important Documents Before Others (Interrupt Transmission)

Interrupt Transmission lets you send your documents before others, eliminating the need to wait until all communications are complete whenever the fax is currently scheduled for multiple communications (Broadcast Transmission or Polling Reception, etc.), or there are other communications already scheduled in memory ahead of yours. * Interrupt Transmission may only be accomplished to a single destination.

* A maximum of 50 communications (including any combination of Interrupt Transmissions, communications that use the timer and Standby Transmissions) can be scheduled at one time.

* Depending on the timing of when you perform the Interrupt Transmission procedure, there are occasions where your documents may not be send “immediately” after the current communication.

* If you want to cancel an Interrupt Transmission, simply remove the set documents. * To cancel an Interrupt Transmission while it is still waiting to start, perform the

same procedure as in “<Canceling a waiting transmission in the Direct Feed Transmission mode...>” on page 3-4.

* If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.

1	Tx”.Press the “Memory TX” key until it changes to “Dir. Feed
		(inch)

(metric)

2	Set the documents you want to transmit in the Document
	Processor or on the platen.

* When the documents are set on the platen, it is necessary, after each page is scanned, to select whether or not you want to transmit more pages and to select the size of each page.

(Refer to page 2-6.)

3	Enter the destination fax number.
	* You can enter the fax number using the keypad,

abbreviated numbers, one-touch keys or the directory. Chain dial keys can be used as well.

4	Press the Start key. The documents will remain in the
	Document Processor or on the platen, without being

scanned, waiting for the transmitting operation to begin.

Once the operation currently in progress is completed, the transmission operation for your documents will begin automatically.

3-7