Xerox FAX System (J) manual Setting the Current Date and Time Date & Time setting

Section 1 Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)

4	Press the “OK” key. The message display will return to
	the same screen as was displayed in step 2.
5	z Registering your station name
	Enter the desired name for your station. (Refer to
	“Entering Characters” on page 2-11.)
	* Your station name can be up to 32 characters in length.
6	In the Character input screen, press the “End” key. The
	message display will return to the same screen as was
	displayed in step 2.
7
	z Registering your station ID
	Use the keypad to enter the desired station ID (4 digits).

* If you want to reset the displayed number to “0000”, simply press the Stop/Clear key.

* If you want to revise the entered number, press the “” or “” cursor key to move the cursor to the number that you want to change. Then enter the correct number as desired.

(inch)

(metric)

8	Press the “Confirm” key. The message display will return
	to the same screen as was displayed in step 2.
9	If you are finished making settings, press the Reset key to
	return to the initial mode.

Setting the Current Date and Time (Date & Time setting)

Set the date and the time that will appear in the message display here. BE SURE that the date and time that you set here are correct since they will serve as a basis for all communications that use the timer.

*Prior to operation, check the message display to make sure that the operation panel is in the initial mode for fax operation. (Refer to “What is the “Initial Mode”?” on page 1-11.)

*If you want to cancel the procedure part way through, press the Reset key.

1	Press the “Register” key. The Registration Select screen
	will appear.

(inch)

(metric)

2	Press the “Date & Time” key. The currently registered
	information will be displayed.

(inch)

(metric)

1-9