31
What to do if …Resetting the language
You can reset the display language to the default setting at any time.
Besides the language, the CONTRAST1 and BRIGHTNESS settings will
also be reset.
1.Press the key combination RESET repeatedly until the display no longer
alters.
2.Hold down the key combination RESET for six seconds.
In the text line you will see LANGUAGE ENGLISH. The word ENGLISH
will flash.
3.Use the direction buttons or to select the required language.
4.Press the OK/START button.
5.If necessary, adjust the values for CONTRAST1 and BRIGHTNESS; see the
“Basic operation” section.
Remedying small malfunctions
In the event of a fault, the light signal at floor level flashes.
If the acoustic signal is activated, warning tones sound if there are
faults.
If one of the following fault messages is displayed in the display during
operation:
–OPEN THE TAP
–DRAIN BLOCKED
Remedy the fault, then re-start the dishwashing cycle. The cycle will
continue.
In the case of other fault messages:
–Cancel the dishwashing cycle.
–Switch the appliance off and on again.
–Select dishwashing cycle.
–Press the OK/START button.
If the fault is displayed again, please contact the Service Force Centre
and inform them of the fault message.
1.not available with all models