Setting the amount of rinse aid required

3 Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from 1-6. The dosage is pre-set to “4” in the factory.

1.Open the dishwasher door.

2.Press the release button on the rinse

aid compartment.

3.Open the cover.

4.Set the dosage level.

5. Press the lid shut until it clicks into place.

6. If rinse aid has leaked out, wipe it away with a cloth.

Activating/deactivating the inflow of rinse aid

When the 3 IN 1 option is activated, you do not need to deactivate the rinse aid inflow.

1.Press the ON/OFF button.

3 If the name of a programme stage is displayed in the display, a dishwashing cycle is active. First of all you must abort the dishwashing cy- cle:

–Press the RESET button. CONFIRM CANCEL? appears in the display.

–Press the OK/START button. This cancels the dishwashing cycle.

2.Go to the RINSE AID setting; see the section “Adapting an option/set- ting”.

3.If required, set the right value.

If the value is ON, the rinse aid inflow is activated; if the value is OFF, it is deactivated.

16