Installation
Water inlet
Connect the water inlet hose to a tap with a 3/4" thread.
The other end of
the inlet hose which connects to the machine can be turned in any direc-
tion. Simply loosen
the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose spe- cially designed for this type of use.
WATER STOP |
|
The inlet hose is provided with a water stop |
|
device, which protects against damage caused |
|
by water leaks in the hose which could devel- |
|
op due to natural ageing of the hose. This |
|
fault is shown by a red sector in the window | A |
“A”. Should this occur, turn the water tap off |
|
and refer to your Service Centre to replace the |
|
hose. | P0352 |
|
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground.
48
