26Installation
Adjusting the height of the plinth
It is important for the dishwasher to be abso- lutely horizontal so that the door seals properly. The adjustable feet are to be turned to the left or right until the dishwasher is horizontal. If there is a space at the bottom of the machine, this can be covered by lowering the plinth.
Adhesive steam protection foil
Fit the steam protection onto the front part of the worktop along the entire width.
Fixing to the adjacent units
Secure the dishwasher by screwing it firmly in position under the bench or to the cupboard be- side it. Use the angular brackets supplied which are fitted into the slots on the top of the dish- washer (see fig.). Tighten the machine in position (upwards or sideways) by using the screws sup- plied (3.5 x 16 mm). Tighten the screws so that the dishwasher cannot tip forward and cause damage when the door is open and loaded. The dishwasher must be secured to the underside of the worktop or to adjacent units by using the brackets supplied. Neglect to do this can cause injury or damage. Under no circumstances may holes be drilled through the sides of the dish-
