INSTALLATION INSTRUCTION
FITTING THE STABILITY BRACKET
The appliance must be installed with a flexible supply pipe. The appliance must also be installed with the stability bracket (supplied with the appliance). Also see Important Safety Requirements, Page 30. These instructions should be read in conjunction with the leaflet packed with the stability bracket.
1.Place the appliance in its intended position and level appliance.
2.Mark off 300 mm from the left hand side of the appliance as shown in dimension 'A' Fig 4a. This is the centre line of the fixing bracket.
3.Draw a line across the front edge of the feet (see Fig 4a) and remove appliance from its position. Mark off dimension 'B' (see Fig 4a) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig. 4b.
4.Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' + 3mm above floor level. (see Fig. 4b).
Reposition appliance and check that top bracket engages into appliance back, as shown in Fig. 4b.
487mm (B)
(C)
100mm
(A)
300mm
Fig 4a
Fig 4b
34
