Installation
DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on both sides of the unit.
1. Screw holes on the side of the unit.
2. Screws. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw 
holes in the bracket.
3. Vehicle’s Factory Mounting Bracket
4. Dashboard or Console
5. Hook (Remove this part)
Note: The mounting sleeve, outer trim ring, and the mounting strap are not used for this method of installation.
PARTS
2 | Metal Keys | 1 | Metal Support Strap |
1 | Hex Nut | 1 | Flat Washer |
1 | Mounting Sleeve (not shown) | 1 | Rubber Mounting Bolt Cover |
1 | Lock Washer | 1 | Faceplate Case |
4 | Screws | 1 | Remote Control |
1 | Sheet Metal Screw | 2 | Wiring Harness (not shown) |
7
