Elite VR500CS-BT manual Installation, Din Front-Mountmethod A

Installation

DIN FRONT-MOUNT (METHOD A)

NOTE: Unit should be installed horizontally or less than a 30° angle.

1.Insert Half Sleeve into dash-board hole and bend mount tabs outwards to secure it.

2.If necessary, attach the mounting strap to the rear of the unit, then attach it with the supplied nut as in fig. 2.

3.Insert the unit into the Half Sleeve until you hear a click sound

4.Place Trim Ring over the unit and installation is completed

(Some vehicles may not need Trim Ring)

Un-installation (Figure 3)

1.Remove Trim Ring and insert Release Keys into left and right side-end holes as shown figure 3 and pull the unit out of the dash- board.

Remove the

half sleeve

E

A

Remove the two transport screws from

the top of the unit before installing.

6