Elite VR500CS-BT manual Notes On Installation, Tools For Installation

Notes On Installation

•Disconnect negative battery terminal before starting installation. Consult the vehi- cle’s owner’s manual for proper instruction.

•The unit is designed for a 12Volt DC negative ground operation system only. Before installing the unit, confirm that your vehicle is a 12Volt DC negative ground system.

•Be sure to connect the color coded leads according to the diagram. Incorrect con- nections may cause the unit to malfunction or damage the vehicle’s electrical sys- tem.

•Be sure to connect the negative (-) speaker leads to the negative (-) speaker termi- nal. Never connect negative (-) speaker leads to chassis ground.

•The unit is only designed for use with 4 speakers. Do not combine output for use with 2 speakers. Do not ground negative speaker leads to the chassis ground.

•Make sure all the connections are completely correct before turning on your unit.

•When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder.

•Do not block vents or heater panels. Blocking them will cause heat to build up in- side and may result in fire.

•After completing the installation and before operating the unit, reconnect the bat- tery. Then press the (RES) button with a pointed object, such as a ball-point pen to set the unit to its initial status.

Tools For Installation

•The 2 removal keys are supplied for removing the old unit and replacing with the “VR500CS-BT”.

The following tools and supplies may also be needed for the installation:

TOOLS	SUPPLIES
• Phillips Screw-drivers	• Machine Screws
• Wire Stripper	• Crimp Connectors
• Wire Cutter	• 14 Gauge Wire for Power Connections
• Hammer	• 14-16 Gauge Speaker Wires
• Pencil
• Electrical Tape
• Electric Drill

The above are NOT INCLUDED with the VR500CS-BT and must be purchased seperately.

4