Elite VR500CS-BT RCA Out, SUB Out & ID3 Tag, Rca Output, Sub Woofer Output, Replacing The Fuse

RCA Out, SUB Out & ID3 Tag

1. RCA OUTPUT

The RCA Output Jacks are on the back of the unit. (Refer to Wiring Diagram) This out- put is for connecting an amplifier, equalizer, or other audio componement that requires a pre-amp out connection. (Red = Right, White = Left) Follow the manufacturers in- structions for the audio component that you are connecting.

2. SUB WOOFER OUTPUT

The Sub Woofer Output Jack is on the back of the unit. (Refer to Wiring Diagram) This output is for connecting an amplifier, that requires a pre-amp out connection.

To use the Subwoofer Out Jack press #/ BAND Button on the front panel, or press the #/BAND Button on the remote control to turn the Sub Woofer Jack ON or OFF.

The unit must have an external amplifier in- stalled to drive the subwoofer.

Follow the manufacturers instructions for the audio component that you are connect- ing.

ID3 TAG & SCROLLING MODES

If an MP3 or WMA file has ID3 Tag informa- tion, it will be displayed on the LCD. ID3 in- formation varies from file to file. If there is no ID3 Tag information, nothing will shown on LCD.

MAINTENANCE

CLEANING THE UNIT

Do not use any liquids to clean this unit. Do not use petroleum distillates to clean this unit.

Use a clean, dry cloth to clean this unit.

REPLACING THE FUSE

Make sure the amperage matches the spec- ified value when replacing the fuse(s). If the fuse is bad, check the power connection and replace the fuse with a new one. If the same problem occurs, this might indicate a malfunction within the unit.

WARNING

When replacing a fuse, do not use a fuse with a higher amperage rating than the fuse originally supplied with your unit, otherwise damage will result to your unit.

21