![](/images/new-backgrounds/1129675/12967537x1.webp)
5. THE ID NUMBER SETTING
When multiple Cameras are laid out adjacently and operated via the wireless remote controller, the Cameras receiving the infrared rays operate in unison in the same way. When each Camera is allocated with a different ID No., the Camera can be controlled independently when its ID No. is specified via the wireless remote controller. The ID Nos. can be allocated for up to 6 Cameras.
(1) Setting an ID No.
• Turn ON only the camera to be set with an ID
17No. Leave other adjacent Cameras in the OFF position. (Unplug their AC adapters from the
18Cameras or wall socket).
•Set the remote ID No. to the Camera. (See "6.
12 | OSD |
setting, close the Menu screen by pressing 12 MENU button. Then, repeat the ID No. setting for all other Cameras in the same way.
(2)Operating the Cameras selectively
•Press 17 ID button, and the LED's of all adjacent Cameras will start blinking (at intervals of 0.2 sec). (To cancel this, press 17 ID button again.) Then, press 18 1 through 6 buttons, and the LED's will go out, and selective operation by specifying the ID No. will be ready. Now, only the selected Camera can be operated via the wireless remote controller.
(3)Canceling the specific ID of the Cameras
•Hold down 17 ID button for over 2 sec, and the blinking LED on the Camera will light up. Then, unhand 17 ID button. Now, the selective operation has been cancelled, and all adjacent Cameras start operation via the wireless remote controller.
•Alternatively, the selective operation by specifying the ID No. can also be cancelled by unplugging the DC jack from the Camera and turning ON the Camera power again.
- 18 -