Barcode Scanner
Driver Installation:
1.Insert your Elo TouchTools CD.
2.On the CD, browse to Touch Monitor Peripherals\Barcode Scanner Startup\Drivers.
3.
4.Once you have finished installing the above: Right click on My Computer and click on Properties. Click on the Hardware tab and then click Device Manager.
5.Double click on USB7210 Converter Module, which should be located in the Other Devices section. Next click on Reinstall Driver.
6.Now your Windows operating system should guide you through the rest of the instal lation process. If any files are requested, please provide the following pathname in your Elo TouchTools CD: Touch Monitor Peripherals\Barcode Scanner Startup\Drivers.
Test Applications:
1.Insert your Elo TouchTools CD.
2.On the CD, browse to Touch Monitor Peripherals\Barcode Scanner Startup\Test Applications.
3.Double click on Scanner Test Application Readme. This document will explain how to test your scanner for basic functionality.
Hall Effect Switch:
The scanner module also adds a Hall Effect Switch (HE Switch) that enables the unit to automatically set the Trigger mode of the Scan Engine depending on the location of anexternal magnet (included in scanner cradle).
The output of the HE Switch switches low (turns ON) when a magnetic field (south polarity) perpendicular to the Hall sensor exceeds the operate point threshold, BOP (typically 100 G magnetic field). When the magnetic field is reduced below the release point, BRP, (typically 45 G magnetic field) the HE Switch output goes high (turns OFF). The Hall Effect Switch goes to the USB Controller’s DSR input. As the HE Switchopens or closes, it causes the USB Controller to initiate a USB Interrupt message to thehost. When the Host Application software detects the DSR input active LOW via theUSB Interrupt and a CDC message (HE Switch is ON), it sends a ‘Continuous Trigger’SSI command.
